HPLC-MS raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2025-08-04 and is reviewed periodically as new material appears.
Laboratory identification of SR9009 typically relies on chromatographic separation coupled to mass spectrometry, often with ultraviolet detection as a secondary check. Nuclear magnetic resonance spectroscopy can confirm molecular structure when a reference standard is available. Because many suppliers sell the compound as a research chemical, independent identity testing is important for experimental reproducibility. A single retention time is not sufficient proof of identity, especially when related compounds may be present. Purity assessments usually report a percentage based on area normalization.
SR9009 is generally described as poorly soluble in water and more soluble in organic solvents such as dimethyl sulfoxide and ethanol. Stock solutions are commonly prepared in an organic solvent before dilution into an aqueous buffer or vehicle. Precipitation can occur if the organic fraction is reduced too quickly or if the final concentration exceeds the compound's solubility limit. Sonication or gentle warming may aid dissolution in some protocols, but excessive heat can promote degradation. Container material and pH can also influence observed solubility.
In laboratory settings, SR9009 is commonly identified by its molecular structure and its interaction with REV-ERB receptors. Vendors may list it under synonyms such as Stenabolic or REV-ERB agonist, but those names do not define purity or identity. Analytical confirmation typically uses high-performance liquid chromatography with ultraviolet detection or liquid chromatography–mass spectrometry. A reference standard is needed to compare retention time and mass spectrum, because the compound can be confused with related research chemicals.
Handling practices for SR9009 focus on minimizing degradation and contamination. The solid is generally stored desiccated at or below -20 °C, protected from light and moisture. Stock solutions are often prepared in dimethyl sulfoxide or ethanol, then aliquoted to avoid repeated freeze–thaw cycles. Aqueous solubility is low, so formulations for animal studies may require cosolvents or suspending agents. Personnel should follow institutional chemical safety procedures, because toxicological data for humans are incomplete.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Visual inspection is not sufficient for identity. |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water; stock solutions use organic solvent. |
| Storage | -20°C, desiccated, protected from light | Limits hydrolysis and photodegradation. |
| Analytical method | HPLC-UV/MS | Used for identity and purity assessment. |
| Synonyms | SR9009, Stenabolic | Naming varies by supplier. |
SR9009 is a synthetic small molecule studied as an agonist of the nuclear receptors REV-ERBα and REV-ERBβ. These receptors help regulate circadian rhythms and metabolic gene expression. In laboratory experiments, SR9009 binds these receptors and alters transcription of genes involved in lipid handling, glucose metabolism, and mitochondrial function. It is not a naturally occurring compound and has no approved therapeutic use. Research interest stems from its ability to modify energy metabolism in cells and animal models.
In rodent studies, SR9009 has been reported to increase mitochondrial content in skeletal muscle and improve exercise endurance under some conditions. These findings led to popular descriptions such as an exercise mimetic, although that term oversimplifies the biology. Effects vary by dose, timing, tissue, and model. The compound's influence on circadian pathways means that time of administration can matter in experiments. Whether similar metabolic changes occur in humans remains largely unexplored in controlled published trials.
The reaction catalyzed by 1-aminocyclopropane-1-carboxylic acid synthase (ACS) is the committed and rate-limiting step in the biosynthesis of ethylene [20], a gaseous plant hormone that is responsible for the initiation of fruit ripening, shoot and root growth and differentiation, leaf and fruit abscission, flower opening, and flower and leaf senescence. (source) It is a pyridoxal phosphate (PLP) dependent gamma-elimination (?). In the gamma elimination, PLP acts as a sink twice (absorbing electrons from two deprotonations). Proposed steps of the reaction mechanism: Formation of the ACS-PLP Schiff Base Imine Exchange Formation of the Quinonoid Intermediate Tyrosine and PLP stabilized 3C-Ring formation Formation of the ACS-PLP Schiff Base The aldehyde of coenzyme PLP reacts to form an imine (Schiff base) linkage with the catalytic domain lysine (278) residue of ACS. Imine exchange An imine exchange occurs, and the amine nitrogen of the substrate, S-Adenosyl methionine, replaces Lys (278) in the imine linkage. (Stabilized by H bonding).
Absorption spectroscopy is spectroscopy that involves techniques that measure the absorption of electromagnetic radiation, as a function of frequency or wavelength, due to its interaction with a sample. The sample absorbs energy, i.e., photons, from the radiating field. The intensity of the absorption varies as a function of frequency, and this variation is the absorption spectrum. Absorption spectroscopy is performed across the electromagnetic spectrum. Absorption spectroscopy is employed as an analytical chemistry tool to determine the presence of a particular substance in a sample and, in many cases, to quantify the amount of the substance present. Infrared and ultraviolet–visible spectroscopy are particularly common in analytical applications. Absorption spectroscopy is also employed in studies of molecular and atomic physics, astronomical spectroscopy and remote sensing. There is a wide range of experimental approaches for measuring absorption spectra. The most common arrangement is to direct a generated beam of radiation at a sample and detect the intensity of the radiation that passes through it. The transmitted energy can be used to calculate the absorption. The source, sample arrangement and detection technique vary significantly depending on the frequency range and the purpose of the experiment. Following are the major types of absorption spectroscopy:
PABA is an intermediate in the synthesis of folate by bacteria, plants, and fungi. Many bacteria, including those found in the human intestinal tract such as E. coli, generate PABA from chorismate by the combined action of the enzymes 4-amino-4-deoxychorismate synthase and 4-amino-4-deoxychorismate lyase. Plants produce PABA in their chloroplasts, and store it as a glucose ester (pABA-Glc) in their tissues. The malarial protozoan Plasmodium only make PABA when necessary, preferring to get it from the surroundings if able to. Some bacteria, including a few found in the human microbiome, are unable to make PABA for themselves but can use PABA to make folate. A few are very efficient at the PABA-to-folate conversion despite not making their own PABA. Sulfonamide drugs are structurally similar to PABA, and their antibacterial activity is due to their ability to interfere with the conversion of PABA to folate by the enzyme dihydropteroate synthetase. Thus, bacterial growth is limited through folate deficiency.
Sources: en.wikipedia.org
The first symptom of CJD is usually rapidly progressive dementia, leading to memory loss, personality changes, and hallucinations. Myoclonus (jerky movements) typically occurs in 90% of cases, but may be absent at initial onset. Other frequently occurring features include anxiety, depression, paranoia, obsessive-compulsive symptoms, and psychosis. This is accompanied by physical problems such as speech impairment, balance and coordination dysfunction (ataxia), changes in gait, and rigid posture. In most people with CJD, these symptoms are accompanied by involuntary movements. Rarely, unusual symptoms like the alien limb phenomenon have been observed. The duration of the disease varies greatly, but sporadic (non-inherited) CJD can be fatal within months or even weeks. Most affected people die six months after initial symptoms appear, often of pneumonia due to impaired coughing reflexes. About 15% of people with CJD survive for two or more years. The symptoms of CJD are caused by the progressive death of the brain's nerve cells, which are associated with the build-up of abnormal prion proteins forming in the brain. When brain tissue from a person with CJD is examined under a microscope, many tiny holes can be seen where the nerve cells have died. Parts of the brain may resemble a sponge where the prions were infecting the areas of the brain.
As anti-angiogenic cancer therapies have achieved widespread use, there has been increased interest in non-invasive monitoring of angiogenesis. One of the most extensively examined targets of angiogenesis is integrin αVβ3. Radiolabeled peptides containing RGD show high affinity and selectivity for integrin αVβ3 and are being investigated as tools to monitor treatment response of tumors via PET imaging. These include 18F-Galacto-RGD, 18F-Fluciclatide-RGD, 18F-RGD-K5, 68Ga-NOTA-RGD, 68Ga-NOTA-PRGD2, 18F-Alfatide, 18F-Alfatide II, and 18F-FPPRGD2. In a meta-analysis of studies using PET/CT in patients with cancer, it was shown that this diagnostic method may be very useful for detecting malignancies and predicting short-term outcomes, although larger-scale studies are needed.
Degradation of an amino acid often begins with transamination, in which its amino group is transferred to α-ketoglutarate, forming glutamate. This process involves transaminases, often the same enzymes used in amino acid synthesis. In many vertebrates, the amino group is subsequently released as ammonia and converted to urea via the urea cycle for excretion. However, amino acid degradation can result in uric acid or ammonia instead, depending on the organism. For example, serine dehydratase converts serine directly to pyruvate and ammonia. After removal of one or more amino groups, the remaining carbon skeleton of an amino acid can serve as a precursor for synthesizing other amino acids, be further metabolized for energy after conversion into intermediates of glycolysis (typically via gluconeogenesis) or of the citric acid cycle, or be used for fatty acid synthesis and storage as triacylglycerol. Amino acids are bidentate ligands, forming transition metal amino acid complexes.
Sources: en.wikipedia.org
Freeze-drying, also known as freeze-casting or ice-templating, offers an alternative to the high temperature and high-pressure requirements of supercritical drying. Additionally, freeze-drying offers more control of the solid structure development by controlling the ice crystal growth during freezing. In this method, a colloidal dispersion of the aerogel precursors is frozen, with the liquid component freezing into different morphologies depending on a variety of factors such as the precursor concentration, type of liquid, temperature of freezing, and freezing container. As this liquid freezes, the solid precursor molecules are forced into the spaces between the growing crystals. Once completely frozen, the frozen liquid is sublimed into a gas through lyophilization, which removes much of the capillary forces, as was observed in supercritical drying. Though typically classified as a "cryogel", aerogels produced through freeze-drying often experience some shrinkage and cracking while also producing a non-homogenous aerogel framework. This often leads to freeze-drying being used for the creation of aerogel powders or as a framework for composite aerogels.
In pharmacology, relative bioavailability measures the bioavailability (estimated as the AUC) of a formulation (A) of a certain drug when compared with another formulation (B) of the same drug, usually an established standard, or through administration via a different route. When the standard consists of intravenously administered drug, this is known as absolute bioavailability (see above). F r e l = 100 ⋅ A U C A ⋅ D B A U C B ⋅ D A {\displaystyle F_{\mathrm {rel} }=100\cdot {\frac {AUC_{\mathrm {A} }\cdot D_{\mathrm {B} }}{AUC_{\mathrm {B} }\cdot D_{\mathrm {A} }}}}
From 2002 to 2004, Pinhasov carried out postdoctoral research at Johnson & Johnson Pharmaceutical Research and Development (Spring House, Pennsylvania, United States), where under the guidance of Dr. Douglas Brenneman he was engaged in the development of drugs for the treatment of neurodegenerative diseases. In 2005, Pinhasov joined the Department of Molecular Biology at Ariel University (formerly the College of Judea and Samaria) as an assistant professor. He was Head of the department from 2008 to 2014. In 2014, Pinhasov was appointed Vice-President and Dean of Research & Development at Ariel University, holding this position until 2020. In 2020 the Senate of Ariel University elected Professor Pinhasov as the Rector of Ariel University, succeeding Professor Michael Zinigrad, who held this office for 12 years. In September 2023, in recognition of his contribution to academic ties between Israel and Kazakhstan, the Senate of Astana Medical University (AMU) awarded Prof. Albert Pinhasov the title of honorary professor.
Sources: en.wikipedia.org
Liquid chromatography with mass spectrometry is a common approach. Ultraviolet detection and nuclear magnetic resonance can support identification when suitable standards are available.
The solid is generally kept cold, dry, and protected from light. Solutions are often frozen in single-use aliquots to reduce repeated freeze-thaw cycles.
It indicates a material sold for laboratory study, not for human use. The label does not guarantee pharmaceutical purity, sterility, or regulatory approval.
Liquid chromatography–mass spectrometry is common for identity and purity checks. High-performance liquid chromatography with ultraviolet detection can also be used. Both methods require a suitable reference standard.